Emerald ash borer can make trees unsafe for deer hunting stands
The Wisconsin Department of Natural Resources (DNR) cautions hunters to avoid placing deer stands in or near ash trees this deer season.
Most ash trees in the southern half of Wisconsin, Door County and the Mississippi River counties are dead or dying from emerald ash borer infestation. Although emerald ash borer is not as widespread in other parts of the state, the invasive insect continues to be found at additional locations throughout the state and unreported infestations are also likely present.
Tree stand accidents are the leading cause of serious injury to deer hunters. It is important to place and maintain tree stands carefully as trees infested with emerald ash borer may unexpectedly snap or drop large branches. Hunters should also be cautious around ash trees when on the ground, especially in windy conditions, as infested trees are susceptible to branch and stem breakage.
“Dead and dying ash trees are structurally weaker than healthy trees, so they are not safe places to put deer stands,” said Bill McNee, DNR Forest Health Specialist. “At this time of year, it can be hard to tell if a tree has been infested by emerald ash borer, so hunters should place deer stands in other types of trees instead.”
No matter the type of treestand, follow these basic safety rules: -- Always wear a full-body harness also known as a fall-arrest system. Connect to your tether line and keep your tether line short. The tether is designed to keep you in the seat, not to catch you after you fall.
-- Always have three points of contact while climbing into and out of the treestand: This means two hands and one foot or two feet and one hand at all times.
-- Always use a haul line to raise and lower your unloaded firearm or bow into and out of the stand. You can also use the haul for other things like a heavy backpack.
-- Use a lifeline when climbing up and down, this keeps you connected from the time you leave the ground to the time you get back down.
Hunters should know how to identify an ash tree to avoid deer stand placement and to keep a lookout for unreported infestations while afield.
Ash trees can be identified through two key features: opposite branching patterns where two branches come off the main stem directly across from each other and compound leaves with 5-11 leaflets.
More information on ash trees and how to identify them is available on the UW-Madison’s Department of Entomology Emerald Ash Borer in Wisconsin webpage.
